铝板存放：应存放在干燥通风的地方，并平放在表面，不要踩踏、撞击。

Aluminum plate storage: It should be stored in a dry and ventilated place, and placed flat on the surface, without stepping or hitting.

铝板搬运：板的四周应同时抬起，以免划伤板的表面。

Aluminum plate handling: The edges of the plate should be lifted simultaneously to avoid scratching the surface of the plate.

铝板切槽：用插床或锣机切槽时，应使用半圆头铣刀。无论对铝板的损伤是否太深，也不太浅，不易折叠，0.2-0.3mm厚的塑料芯应与铝板一起弯曲，以增加强度和韧性，否则铝板弯曲时可能断裂或漆膜破裂。

Aluminum plate groove cutting: When using a slotting machine or gong machine to cut grooves, a semi-circular end milling cutter should be used. Regardless of whether the damage to the aluminum plate is too deep, not too shallow, and not easy to fold, plastic cores with a thickness of 0.2-0.3mm should be bent together with the aluminum plate to increase strength and toughness, otherwise the aluminum plate may break or the paint film may break when bent.

铝板弯曲：弯曲边缘时，应力均匀，成型一次，不要反复弯曲，否则铝板可能断裂。

Aluminum plate bending: When bending the edges, the stress should be uniform and formed once. Do not bend repeatedly, otherwise the aluminum plate may break.

铝板电弧加工：应采用专用弯曲设备对电弧进行加工，使板材逐渐达到所需的表面，不得一次弯曲。

Aluminum plate arc processing: Special bending equipment should be used to process the arc, so that the plate gradually reaches the required surface and cannot be bent in one go.

铝板批次：同一类型不同批次的铝板可能存在色差。在销售和使用不同批次的纸张时，应增加色差比较程序。

Aluminum plate batch: There may be color differences between aluminum plates of the same type in different batches. When selling and using different batches of paper, a color difference comparison program should be added.

铝板安装方向：同色铝板安装在同一平面上时，流向应一致，否则会产生视觉色差。

Aluminum plate installation direction: When the same colored aluminum plate is installed on the same plane, the flow direction should be consistent, otherwise it will cause visual color difference.

铝板撕膜：铝板安装后45天内撕下保护膜，否则撕膜困难或发生胶转移。

Aluminum plate film tearing: Remove the protective film from the aluminum plate within 45 days after installation, otherwise it will be difficult to tear the film or adhesive transfer may occur.

铝板使用条件：室内墙板应在室内使用，不得安装在室外，以保证使用效果和使用寿命。

Aluminum panel usage conditions: Indoor wall panels should be used indoors and not installed outdoors to ensure their effectiveness and lifespan.

本文由铝板生产厂家提供技术支持，更多的详细精彩内容请点击我们的网站 http://www.jndclyyxgs.com我们将会全心全意为您提供满意的服务。

This article is supported by aluminum plate manufacturers. For more detailed and exciting content, please click on our website http://www.jndclyyxgs.com We will wholeheartedly provide you with satisfactory service.